Charging program selection
Once you connected the battery charger to the power outlet, a LED bar will show you the active charging mode. To change the charging mode, please follow this procedure:
- With the device disconnected from the battery and from the power outlet, connect the clamps to the device and put the red and the black clamps together (creating a permanent short circuit).
- Connect the device to the power outlet. The active charging mode will change and it will be displayed by the correspondent LEDs: “Lead-Acid” for lead-acid batteries, “Lithium/LiFePO4” for lithium batteries, and the “CAN-Bus” LED on when the modes “Lead-Acid CAN-Bus” or “Lithium CAN-Bus” are activated.
- Disconnect the device from the power outlet and separate the clamps. The selected charging mode will be kept in memory until you repeat this procedure
Recharging, Reconditioning and Mantenance- 100% automatic and complete
- Once selected the right programme for your battery, you have just to connect BC K900 EVO+ to the battery to start the charging procedure, that is completely automatic. BC K900 EVO+ bringsyour battery to the maintenance phase, recovering it gently if necessary, giving it energy and power during the charging and desulfation steps and keeping it constantly under control, from the initial test to the end-cycle battery analysis.